Altered charms for charm bracelet swap

I'm involved in two charm bracelet swaps. This is the first set of charms that I've made. They are pretty simple but I'm happy with how they turned out. Here's the scoop:
Materials:
1" wood disk
Various collage images
Crystal Laquer (made by Sakura Hobby Craft)
14K Gold leafing pen
Ultimate Glue
Dremel w/tiny drill bit
20 gauge wire
Various beads/charms
Acrylic paint/varnish

First drill a hole near the top (on the face of the disk) big enough for a jump ring. Then drill a hole on the side of the disk - in line with the top hole. This is where you will add your dangle. Paint the entire disk in your choice of color. Cut a collage image to fit the disk (use a 1" circle punch if you have one - I don't but I'm going to buy one soon!). Glue it on. Cut out your words - glue them on. Color around the edge of the disk with the 14K gold leafing pen, also color the edges of the collage image. Squeeze the Crystal Laquer around the edges of the disk then proceed to fill in the disk wiht the laquer. Let it dry for an hour or two. Take your 20 gauge wire and cut a piece about 1 1/4". Bend the very tip over and squish it. Dip the tip into the Ultimate Glue and then 'screw' it into the hole on the side of the disk. Let dry for a few minutes. Add beads and bend wire into a spiral or a design. Make a jump ring for the top if you don't have any on hand.